Policy on Intellectual Property Right (IPR)
Annex
1 Introduction
2 Terms and definitions for the purpose of this Recommendation
2.1 Antenna diagram for fixed reception
2.2 Antenna factor
2.3 Bit error ratio
2.4 Cell
2.5 C/N
2.6 Coverage area
2.7 Service area
2.8 Coverage prediction
2.9 Crest factor
2.10 Directional discrimination
2.11 Guard interval
2.12 Height loss
2.13 Interfering field strength
2.14 Median
2.15 Minimum median field strength (Emed)
2.16 MFN
2.17 Minimum equivalent signal level
2.18 Minimum wanted (equivalent) field strength (Emin)
2.19 Network gain
2.20 Protection ratio
2.21 Quasi error-free reception
2.22 Receiving field strength
2.23 Receiving scenario
2.24 Reception channel
2.25 The GE06 Agreement
2.26 Self-interference inside an SFN
2.27 Single-frequency network
2.28 Standard deviation
2.29 Standard deviation of the spectral amplitudes (σsp)
2.30 σsp‑correction (Cσ)
2.31 Small area
2.32 Substitution transmitter
2.33 Synchronisation
2.34 System variant
2.35 Wanted field strength
3 Measurement methods
Attachment 1 to the Annex Verifying the coverage prediction for fixed
reception
A1.1 Selection of measurement locations
A1.2 Necessary measurement equipment
A1.3 Required information
A1.4 Measurement setup
A1.5 Measurement procedure
A1.6 External interference
A1.7 Evaluation of the results
A1.7.1 Verifying homogeneous field strength distribution
A1.7.2 Correction for the reception channel
A1.7.3 Correction for time probability of interfering
signals
A1.7.4 Calculation of the total field strength
A1.7.5 Decision whether a measurement point is covered
A1.8 Result presentation
A1.9 Verification of planned coverage
Attachment 2 to the Annex Verifying the coverage prediction for portable
reception
A2.1 Measurement principle
Example:
A2.2 Necessary measurement equipment
A2.3 Measurement procedure
A2.4 Evaluation of the results
A2.5 Result presentation
Attachment 3 to the Annex Alternative method to determine the coverage border
of DVB-T/T2 transmitters and networks for specific cases
A3.1 Introduction
A3.2 Measured parameters of the signal
A3.3 Equipment requirements
A3.4 Measurement planning
A3.5 Measurement procedure
A3.6 Processing of measurement results
A3.7 Measurements in SFN
Attachment 4 to the Annex Method to measure the coverage of DVB-T/T2 service
for fixed reception in defined areas
A4.1 Introduction
A4.2 Equipment requirements
A4.3 Measurement planning
A4.4 Measurement procedure
A4.5 Processing of the measurements
A4.6 Display of measurement results
Attachment 5 to the Annex Required corrections of measurement results
A5.1 Reception channel correction (σsp‑correction)
A5.2 Location probability correction
A5.3 Total correction for indoor coverage