Policy on Intellectual Property Right (IPR)
Annex 1 Protection criteria of radiocommunication services operating
below 30 MHz and between 80 and 470 MHz
Annex 2 Examples of national regulations
Appendix 1 to Annex 2 United States of America Regulation of RF
emissions from power line communication systems in the United States of America
1
Introduction
2
Definition of BPL
3
Emission limits
4
Special frequency protections
4.1
Frequency band exclusions
4.2
Geographical exclusion zones
4.3
Consultation area requirements
4.4
Consultation area notice requirements
4.5
Public safety licensee notice requirements
5
Interference mitigation
5.1
Interference complaint procedures
5.2
Adaptive interference techniques
5.3
Access BPL database requirements
6
Measurement guidelines
6.1
Existing measurement requirements
6.2
New/modified measurement requirements
7 Equipment
authorization
8
Conclusion
Appendix 2 to Annex 2 Germany
Annex 1 to ECC Recommendation (05)04 Guidelines for the assessment of
radio interference cases caused by disturbing radiations generated by wire-line
telecommunication networks
Unresolved interference
complaint
Interference resolution
Compliance investigation
Explanation of flowchart
Addendum to Annex 1 of ECC Recommendation (05)04 Explanation of
flowchart in Annex 1 to ECC Recommendation (05)04
Annex 2 to ECC Recommendation (05)04 Mitigation techniques and
considerations, including limits of the disturbance field strength, applicable
to blocks 3 and 4 of flowchart in Annex 1 to ECC Recommendation (05)04
1
Technical aspects
2
Economic and political aspects
3
Regulatory aspects
4
Assessment of all criteria and circumstances
Appendix 3 to Annex 2 Japanese regulations for the power line high data
rate telecommunication systems
1
Fundamental principle
2
Equipment allowed to be used: In-house PLT equipment only
3
Limits
3.1
Conducted emission at the mains port
3.2
Conducted emission at the telecommunication port
3.3
Radiated emission
4
Derivation of the limits
4.1
Procedures
4.2
PLT installation model and draft limits
4.3
Japanese PLT limits
5
Measurement conditions for the PLT common-mode current
Appendix 4 to Annex 2 Federative Republic of Brazil Brazilian
regulation on power line high data rate telecommunication systems
1
Introduction
2
General requirements
3
Measurements
4
Specific requirements
4.1
Frequency band exclusions
4.2
Exclusion zones
4.3
Preventive action
4.4
Coordination process
5
Conclusion
Appendix 5 to Annex 2 Republic of Korea
1
Limits
1.1
Limits for conducted emission at power ports
1.2
Limits for radiated disturbance
1.3
The prohibited frequency band as use of PLT
2
Measurement method of radiated disturbance
2.1
Measurement methods in frequency range 9 kHz to 30 MHz
2.2
Measurement methods in frequency range 30 MHz to 1 000 MHz