1
Scope
2 References
3 Definitions
4 Abbreviations
5 Frequency accuracy
6 Pull-in, hold-in, and pull-out
ranges
6.1 Pull-in range
6.2 Hold-in range
6.3 Pull-out range
7 Noise generation
7.1 Wander in locked mode
7.2 Non-locked Wander
7.3 Jitter
8
Noise tolerance
8.1 Wander tolerance
8.2 Jitter tolerance
9
Noise transfer
10 Transient response and holdover
performance
10.1 Short-term phase transient response
10.2 Long-term phase transient response
(Holdover)
10.3 Phase response to input signal
interruptions
10.4 Phase discontinuity
11 Interfaces
Appendix I – Guidance on the relationship between network limits and input
noise tolerances
I.1 Option 1 network limits
I.2 Option 2 network limits
Appendix II –
Considerations on bandwidth requirements, noise accumulation and payload wander
accumulation
II.1 Introduction
II.2 Relevant network requirements and
assumptions for Option 1
II.3 Relevant network requirements and
assumptions for Option 2