1 Scope
2 References
3 Definitions
3.1 Terms defined elsewhere
3.2 Terms defined in this Recommendation
4 Abbreviations and acronyms
5 Reference models and system requirements
5.1 System reference models
5.2 Application reference models
5.3 FTU protocol reference model
5.4 FTU functional model
5.5 INP system requirements
6 Profiles
7 Transmission medium interface characteristics
8 Transport protocol specific transmission convergence (TPS‑TC)
function
9 Physical media specific transmission convergence (PMS‑TC)
sub-layer
10 Physical media dependent (PMD) function
10.9 Probe sequences (new in this Recommendation)
11 Operation and maintenance (OAM)
12 Link activation methods and procedures
13 Online reconfiguration (OLR)
14 Electrical requirements
Annex A to Annex C
Annex D – Operation with dynamic time assignment in a crosstalk environment
Annex E to Annex Q
Annex R – Showtime reconfiguration
Annex S – NT software upgrade
Annex T – Dynamic time assignment (DTA) – higher-layer control aspects
Annex U
Annex V – Targeted generalized vectoring with non-active ITU-T G.9701
supporting lines (TGVN)
Annex W
Annex X – Operation without multiline coordination intended for a
crosstalk-free environment
X.1 Scope
X.2 Definitions
X.3 Abbreviations and acronyms
X.4 Reference model(s)
X.5 Profiles
X.6 Independent dynamic time assignment (iDTA)
X.7 Initialization messages
X.8 Discontinuous operation
X.9 Online reconfiguration
X.10 Initialization
X.11 Low power states
X.12 Adaptation to the coaxial cable medium
Annex Y – Upstream dynamic resource reports
Annex Z – Cross-layer traffic monitoring functions and link state control
Appendix I – Wiring topologies and reference loops
Appendix II – Example OLR use cases
Appendix III – Motivation of MTBE accelerated test
Appendix IV – Targeted generalized vectoring with active ITU-T G.9701
supporting lines (TGVA)
Appendix V – Retransmission buffer size and the achievable bit-rate
Appendix VI – Example applications of discontinuous operation
Appendix VII – Calculation of loop attenuation (LATN)
Appendix VIII – Impulse noise monitoring – detection and interpretation of
impulse noise using clusters of corrupted DTUs
Appendix IX – Examples of the cDTA procedure
Appendix X – Configuration parameters describing preferred net data rate
Appendix XI – Fastback use case descriptions